[ale] Hardware problems continue on new system

[Liberie F. Cunha-Neto]

you are overcloking this machine ?
i see in my A7n8X-X not stay stable if the FSB is more than 198Mhz

try adjust your FSB , Vcore and mult.

my AthlonXP 1700 , is running a Chip MHz 2330.07 STABLE
and i'm using Gentoo Linux , work at 2450Mhz but Not Stable and give-me
a lot GCC errors




On Sat, 2004-03-20 at 22:20, Jim Seymour wrote:
> Hi All,
> 
> 	The hardware problems continue on the new system. I am at the 
> point of taking the parts out to put my old system back together. As was 
> suggested before I removed my scsi card to run memtest86. The results 
> were the same - huge amounts of errors at the end of test #5 and beginning 
> of #6. At one time it was showing 70,000+ errors after going 
> through test #6. I am using 2 512mb sticks and have tried them alone 
> with the same results. The memory has been checked by me and another 
> member as being supported on this mb. So at this point I would like some 
> advice on what to fork out the $$ to replace. This is a system I use 
> daily and cannot have down for a long time. The motherboard reports the 
> memory frequency as 200MHz? Dmesg returns 333MHz as the host bus speed? 
> To me the problem centers around this discrepancy. The bios setup 
> indicates that all is set up correctly for the cpu and memory. All of 
> these parts are new. My thoughts are a botched mb. I need input from 
> those of you more experienced in this area.
> 
> Asus A7N8X-X mb
> AMD XP2600 (barton)
> Kingston KVR400X64C25/512 PC3200 DDR
> Sapphire Radeon 9200 agp 256mb
> Enlight 420w ps
> 
> Many thanks,
> 
> Jim Seymour
> _______________________________________________
> Ale mailing list
> Ale at ale.org
> http://www.ale.org/mailman/listinfo/ale