[ale] Getting worker to work

Keith Hopkins hne at hopnet.net
Tue Oct 1 11:36:16 EDT 2002


ChangingLINKS.com wrote:
> Can anyone guess what is going on? 

You didn't RTFM.

> 
> 
> [root at change worker-2.6.1]# ./configure
> checking for a BSD compatible install... /usr/bin/install -c
[snip]
> checking how to run the C preprocessor... gcc -E
> checking for X... no
> configure: error: X Window libraries and headers not found!
> *********************************************************************
> * Check your X installation (many distributions have these files in *
> * the ...devel-packages (e.g. xdevel)).                             *
> *********************************************************************

You didn't say, but assuming your system uses rpms (not Debian/Gentoo/et.al.) type "rpm -qa | grep X | grep devel"
   if it comes up empty, then just like it says, you don't have the development packages for X installed.  Go install them.

> [root at change worker-2.6.1]# make
> make: *** No targets specified and no makefile found.  Stop.

This will not work properly until ./configure completes without error.

-- 
Lost in Tokyo,
   Keith



---
This message has been sent through the ALE general discussion list.
See http://www.ale.org/mailing-lists.shtml for more info. Problems should be 
sent to listmaster at ale dot org.






More information about the Ale mailing list