[ale] ethernet switch issues

Wandered Inn esoteric at denali.atlnet.com
Wed Jun 13 13:52:04 EDT 2001


Michael Curtis wrote:
> 
> What kind of NICs are you using?  I had a similar problem with 3com 3c905's
> (the "a" series) not autosensing between 10 and 100 (I believe this was
> fixed in the "b" and up series), and had to use their diag software to force
> the thing to go to 100.  But then again we were first using 10MB hubs and
> switched to a 10/100 config.  In any case, we would get a link light and the
> led would say 100, but would fail to work until they were set.

One is a netgear, the other is a linksys.  Both have leds on the back of
the cards that indicate they are going to 100/full duplex.  Obviously I
would suspect the Linksys card before the netgear, since the switch is
netgear.  I'm going to dig out the docs on these cards to see if there
are any dips I can set that will force them to 100.

> 
> -Mike
> -----Original Message-----
> From: SAngell at nan.net <SAngell at nan.net>
> To: esoteric at denali.atlnet.com <esoteric at denali.atlnet.com>
> Cc: ale at ale.org <ale at ale.org>
> Date: Wednesday, June 13, 2001 12:33 PM
> Subject: Re: [ale] ethernet switch issues
> 
> >
> >
> >I am sure this may seem overly obvious but have you tried a crossover cable
> >between the suspect NIC and another station that is working properly? I
> have
> >personally never seen "cheap" cables cause problems unless they were
> noticeably
> >defective or were used over distances close to max.
> >
> >I would first suggest using a crossover cable and trying simple pings to
> verify
> >that both NICs are functioning. Do not always assume that if the lights are
> on
> >that someone is home. NICS, especially cheaper ones, only see that there is
> >traffic on the lines. This could be ANY traffic.  I have used some Netgear
> >products in the past with no problems so I doubt that it is the switch
> causing
> >your problems. What were you using as a connection point before the switch?
> Or
> >is this your first attempt to network these stations?
> >
> >Hope this helps.
> >
> >Steve Angell,  MCSE, CCNA
> >MIS Operations Manager
> >TSYS Total Debt Management
> >Phone 770-409-5570
> >Fax      770-416-1752
> >
> >
> >|--------+---------------------------->
> >|        |          Wandered Inn      |
> >|        |          <esoteric at denali.a|
> >|        |          tlnet.com>        |
> >|        |                            |
> >|        |          06/13/01 12:10 PM |
> >|        |                            |
> >|--------+---------------------------->
> >  >--------------------------------------------------------|
> >  |                                                        |
> >  |       To:     ALE <ale at ale.org>                        |
> >  |       cc:     (bcc: Steve Angell/tdm)                  |
> >  |       Subject:     [ale] ethernet switch issues        |
> >  >--------------------------------------------------------|
> >
> >
> >
> >
> >
> >I've replaced the sohoware switch with a netgear switch and I still
> >can't get this thing to work.  Netgear support told me it was my cables,
> >that 100baset can have problems with cheap cables.  I was using Belkin
> >cables, which I believe are pretty decent.  I've since made two very
> >short cat 5 cables and tried these, but still no luck.
> >
> >Anyone else had any such problems?  I'm now suspecting it's probably one
> >of the cards I'm using that is not functioning properly at 100baseT,
> >although both have leds indicating they are properly autosensing the
> >proper speed.
> >
> >I can't believe it's this difficult to get these things to work.
> >
> >--
> >Until later: Geoffrey         esoteric at denali.atlnet.com
> >
> >"Great spirits have always found violent opposition from mediocre minds.
> >The latter cannot understand it when a man does not thoughtlessly submit
> >to hereditary prejudices but honestly and courageously uses his
> >intelligence." - Albert Einstein
> >--
> >To unsubscribe: mail majordomo at ale.org with "unsubscribe ale" in message
> body.
> >
> >
> >
> >--
> >To unsubscribe: mail majordomo at ale.org with "unsubscribe ale" in message
> body.
> 
> --
> To unsubscribe: mail majordomo at ale.org with "unsubscribe ale" in message body.

--
Until later: Geoffrey		esoteric at denali.atlnet.com

"Great spirits have always found violent opposition from mediocre minds.
The latter cannot understand it when a man does not thoughtlessly submit
to hereditary prejudices but honestly and courageously uses his
intelligence." - Albert Einstein
--
To unsubscribe: mail majordomo at ale.org with "unsubscribe ale" in message body.





More information about the Ale mailing list