[ale] lm sensors success...

[Wandered Inn]

I've successfully installed lm_sensors on my box and received the
following output:

as99127f-i2c-0-2d
Adapter: SMBus PIIX4 adapter at e800
Algorithm: Non-I2C SMBus adapter
VCore 1:   +2.03 V  (min =  +1.80 V, max =  +2.20 V)
VCore 2:   +2.51 V  (min =  +1.80 V, max =  +2.20 V)       ALARM
+3.3V:     +3.45 V  (min =  +2.97 V, max =  +3.63 V)
+5V:       +4.94 V  (min =  +4.50 V, max =  +5.48 V)
+12V:     +11.67 V  (min = +10.79 V, max = +13.11 V)
-12V:     -10.60 V  (min = -10.78 V, max = -13.18 V)       ALARM
-5V:       -5.48 V  (min =  -4.50 V, max =  -5.48 V)
fan1:        0 RPM  (min = 3000 RPM, div = 2)              ALARM
fan2:        0 RPM  (min = 3000 RPM, div = 2)              ALARM
fan3:        0 RPM  (min = 3000 RPM, div = 2)              ALARM
temp1:    +37 C   (limit = +60 C, hysteresis = +50 C)
temp2:    +38.5 C   (limit = +60.0 C, hysteresis = +50.0 C)
temp3:    +112.2 C   (limit = +60.0 C, hysteresis = +50.0 C)
vid:      +2.00 V
alarms:   Chassis intrusion detection                      ALARM
beep_enable:
          Sound alarm enabled

Pretty cool, although 'VCore 2' and 'temp3' look a bit high there.  I'll
be checking it out.

Anyway, I tried the rpm approach with no luck, so I ended up going with
compiling my own.  Pretty straight forward, just make sure you read the
README's and INSTALL files.  Follow the installation instructions and
then run sensors-detect to see if your hardware is located.

After than, executing 'sensors' produces the above output.  Now I'll see
if I can output the temperature to that unused digital led.

--
Until later: Geoffrey		esoteric at denali.atlnet.com

"Great spirits have always found violent opposition from mediocre minds.
The
latter cannot understand it when a man does not thoughtlessly submit to
hereditary prejudices but honestly and courageously uses his
intelligence."
- Albert Einstein
--
To unsubscribe: mail majordomo at ale.org with "unsubscribe ale" in message body.