[ale] ISA Ethernet: 10base T that Linuxconf recognizes

[Gary Maltzen]

The NE2000 clones seem to be readily available and not very expensive
($10-20); you should be able to find one at a CompUSA.

If not detected at boot, use the command 'modprobe ne' to load the NE*000
driver and display the IO and IRQ address; then edit /etc/conf.modules
adding the following (example) lines:

  alias eth0 ne
  alias eth1 ne
  options eth0 io=0x1111 irq=1
  options eth1 io=0x2222 irq=2

I just finished bringing up a new system with one of these type cards.

Gary/Minneapolis(68F/Sun)

-----Original Message-----
 From: Steve Jones <SJones at btsquared.com>

I am looking for recomendations for an ISA ethernet card (two actually) that
does 10baseT and is recognized by Linuxconf in RH5.2.

A pointer to a distributer (online or in the atlanta area) would also be
appreciated.