[ale] HOW2 install BellSouth DSL with a USB link rather than Ethernet ?

[Ben Coleman]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Dan Lambert wrote:
> All you need to do is to use the Ethernet cable to connect the Westel to 
> the hub, and then you can leave your computer connected as it is.
> 
> The modem doesn't have to be directly connected to the computer to 
> function. Do away with the USB, and avoid the issue all together.
> 
> That one change should get you on line and going!

If the Westell is configured to do PPPOE itself and operating as a NATting
router (which I believe is the default configuration from BellSouth), yes,
this should do fine.  If it's set up in bridged mode (where the attached
computer needs to run PPPOE), it may be another story.

Ben
- --
Ben Coleman oloryn at benshome.net    | The attempt to legislatively
http://oloryn.home.mindspring.com/ | micromanage equality results, at best,
Amateur Radio NJ8J                 | in equal misery and mediocrity for all.
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.2.2 (MingW32)
Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org

iD8DBQFFHoeEQBcsLKrSBE8RAq79AJ9nYjSgAocXL+90yrWl6D3gUgIdvwCeJoEX
4n551lGVH6mD8QPGNePmvWE=
=CoBm
-----END PGP SIGNATURE-----