[ale] half/full duplex on RH 9

[Dow Hurst]

For your ethernet interface driver you can usually feed a parameter in 
when configuring the interface that will force half or full duplex.
Check www.scyld.com for more info on the drivers.
Dow


Frank Zamenski wrote:

>An associate here at work asked me how to set RH9 x86 eth0 to full 
>duplex (with Solaris, I would use ndd). But offhand, I don't recall how 
>this is done in RH, and am not on his machine to look around.
>
>Thanks.
>-fgz
>
>
>_______________________________________________
>Ale mailing list
>Ale at ale.org
>http://www.ale.org/mailman/listinfo/ale
>
>  
>

-- 
__________________________________________________________
Dow Hurst                  Office: 770-499-3428            *
Systems Support Specialist    Fax: 770-423-6744            *
1000 Chastain Rd. Bldg. 12                                 *
Chemistry Department SC428  Email:   dhurst at kennesaw.edu   *
Kennesaw State University         Dow.Hurst at mindspring.com *
Kennesaw, GA 30144                                         *
*****************************************************************
This message (including any attachments) contains confidential  *
information intended for a specific individual and purpose,     *
and is protected by law.  If you are not the intended recipient,*
you should delete this message and are hereby notified that     *
any disclosure, copying, or distribution of this message, or    *
the taking of any action based on it, is strictly prohibited.   *
*****************************************************************


_______________________________________________
Ale mailing list
Ale at ale.org
http://www.ale.org/mailman/listinfo/ale