[ale] TNT2 + FIC VIA-503+

[Tony Scalzitti]

I don't think it is related but the FIC 2013 boards run the PCI bus at ~5v
rather then ~3.3v and have problems with PCI cards that can't deal with it

-T

----- Original Message -----
 From: No One <mainwizard at vei.net>
Cc: <ale at ale.org>
Sent: Friday, December 31, 1999 1:46 PM
Subject: Re: [ale] TNT2 + FIC VIA-503+


> Check your card to be sure it is fully seated. If you had a PCI card and
switched to an
> AGP card, you may have to make changes in your bios settings. You may have
to reinstall
> the original video card to do so. Also be sure that your on board agp
video (if you have
> it) is disabled. You could be getting a conflict.
> Ed.
>
>
> James Godfrey wrote:
>
> > the beep code says that you have a video adapter problem.  Given the
season it is possible that your display adapter was damaged from ESD.  It
may not be the cheapest route, but purchasing a new display adapter is
probably your only solution.
> >
> > benjie
> >
> > >When I try to boot with it, I get a black screen and
> > >a long beep, followed by two shorter beeps.
> > >
> >
>
> --------------------------------------------------------------------------
--
> > Access your e-mail anywhere, at any time.
> > Get your FREE BellSouth Web Mail account today!
> > http://webmail.bellsouth.net
>
> --------------------------------------------------------------------------
--
> > --
> > To unsubscribe: mail majordomo at ale.org with "unsubscribe ale" in message
body.
>
> --
> To unsubscribe: mail majordomo at ale.org with "unsubscribe ale" in message
body.
>


--
To unsubscribe: mail majordomo at ale.org with "unsubscribe ale" in message body.